Sliding Box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple box with a sliding lid
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 49
- Makes
- 0
- Views
- 571
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Sliding Box
This is a simple box with a sliding lid.
Tolerances are not super tight (0.3 mm margin), so even if your dimensional accuracy is not perfect it should print ok.
Printing
Material: PLA
Layers: 0.2 mm +/- 0.1 mm Adaptive Layers (to speed up the print)
Raft: No
Support: No*
Infill: 15%
Walls: 3
*: The bottom would actually need supports, due to the steep angle of the groove where the lid slides. To avoid wasting material with supports and to reduce total print time, I have uploaded a version of the bottom of the box split in two parts.
Using this version, you can print the two halves on their flat side, without supports, and then glue them together.
