Ozito Water Pump Filter Wrench
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filter wrench to remove the clear outside housing and access the filter for cleaning.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 54
- Makes
- 0
- Views
- 335
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
The Ozito Pre-Filter kit clear housing was impossible to remove by hand after it had been outside for a couple of weeks. None of the water filter wrenches I had were of suitable size and nothing else I had would wrangle it off…
… so I made the wrench.
Recommend printing just the bottom layers (around 1 to 2mm thick) for a test fit. It should feel snug at the middle part of the clear housing, if not, adjust by +1% X & Y until it does.
Tip: Remember to put silicone grease on the threads and O-ring on the clear housing to make it easier to remove next time.
Printing:
- PLA+
- 6 walls on a 0.6mm nozzle
- 50% cubic infill
- 5 top and 5 bottom