Kitchenaid Mixer Accessory Holder Remix

I have printed a bunch of different Kitchenaid stand mixer accessory hangers before, and most of the break because of the orientation of the layer lines and the twisting force you usually need to apply to get the things to hang properly.  What I liked about the model from @frez_knee was that the mounting hardware was integrated as the primary structure, rather than relying on double faced tape, or command srtrips.  This should make it almost impossible to break the hook.

For this remix, I placed 3 of the original on a single panel that can be mounted underneath the cabinet.  I also rounded over the end of the hooks a little to prevent some ringing when printing.  And finally, I widened the thru-hole for the mounting hardware just a little to make installation a little easier.