Sundvik Book Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Book holder designed to clip on the side of the IKEA Sundvik crib.
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 96
- Makes
- 0
- Views
- 718
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Share Alike
This is book holder design to clip on the side of the IKEA Sundvik crib. I made two version. A plain one (easier to print) and a honeycomb version. The honeycomb is 25% lighter than the plain version, it's easier to see the book in the holder but the downside is the angle of the honeycomb is at 60°. It's printable but the surface finish is only okay.
I highly recommend PETG. I'm pretty certain that PLA will snap in two part when clipping (I haven't tried it).
Print with the “S” laying on the bed, no support required. I used brim for both to prevent lifting. Rectilinear infill @ 15% for better strength.
To be safely used near a crib and child under 3, print without scaling, use non-toxic material and remove any sharp edges. Also, the hexagon are 15.4mm minimum opening. This meet JPMA opening size to prevent finger entrapment.