Sundvik Book Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Book holder designed to clip on the side of the IKEA Sundvik crib.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 96
- Wydruki
- 0
- Wyświetlenia
- 718
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Share Alike
This is book holder design to clip on the side of the IKEA Sundvik crib. I made two version. A plain one (easier to print) and a honeycomb version. The honeycomb is 25% lighter than the plain version, it's easier to see the book in the holder but the downside is the angle of the honeycomb is at 60°. It's printable but the surface finish is only okay.
I highly recommend PETG. I'm pretty certain that PLA will snap in two part when clipping (I haven't tried it).
Print with the “S” laying on the bed, no support required. I used brim for both to prevent lifting. Rectilinear infill @ 15% for better strength.
To be safely used near a crib and child under 3, print without scaling, use non-toxic material and remove any sharp edges. Also, the hexagon are 15.4mm minimum opening. This meet JPMA opening size to prevent finger entrapment.