OLED Wemos D1 Mini Wedge (run Octoprint monitor or weather display)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Please post a make if you make this! :) Demo of print status screens: https://imgur.com/a/yX2dhjJ Compact Case for…
- Rating
- 4.571 / 5
- Likes
- 69
- Downloads
- 616
- Makes
- 8
- Views
- 3,391
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Please post a make if you make this! :)
Demo of print status screens: https://imgur.com/a/yX2dhjJ
Compact Case for Wemos D1 mini wifi ESP8266 with 0.96 Inch Yellow and Blue I2C IIC Serial 128X64 OLED Display.
Uses (1) 10mm M3 screw for assembly.
Used this wire - great for projects!
I used Ziro marble PLA to print this one.
A few examples of what you can use this for(hardware and software links within):
(4) wire connections documented in the below software links.
Octoprint software: https://www.thingiverse.com/thing:2884823
Weather software: https://www.thingiverse.com/thing:857858
I wanted as small of a case as I could have with an upright display view to put on my desk.
You need to bend over the (4) pins so they clear the D1 mini(see pic) or just unsolder the 4 pin connector and remove it and solder the wire directly to the board. I found that bending one pin at a time avoid torquing the connection too much.
I redesigned the side to include a pass-thru lever to press the reset button when required vs unplugging/replugging the USB power connector.
To ensure a minimal gap between the body and cap, sand the surfaces of both the body and side panel flat where they contact each other.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Doesn't Matter
Infill:
15%
Filament: PolyMaker PLA
Notes:
You can try printing without support for the display opening but I got cleaner results with the bridging with supports.
Category: 3D Printer Accessories