Mixbox controller
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slightly overengineered mixbox controller case for GP2040ce and MX switches.
- Rating
- 4 / 5
- Likes
- 15
- Downloads
- 199
- Makes
- 0
- Views
- 1,277
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial
First of all, I want to apologize to all the people who know how to solder for what they see in my photos.
Not so long ago, I decided that I needed a Mixbox-style controller. I downloaded and printed the case I liked, but it turned out that my board - a Raspberry PI clone with a Type C connector - was three millimeters larger than the original one and therefore did not fit there. That's why I decided to make my own case in the same style, but improve some aspects and make it a little more versatile.
The board is attached to the clip, and the screen and auxiliary buttons are attached to the latches. The assembly will require 12 keyboard switches, 3 tactile switches measuring 6x6 millimeters, 4 ten-millimeter screws, a nut with a diameter of 6 millimeters, a bolt with a diameter of 6 mm and a length of up to 10 millimeters and a controller with RP2040. Later, I tried to install other raspberry pi pic clones in this case, they were all slightly different lengths, but they were installed into the clip without any problems.
Print face-to-table, no supports required