1 / 2
Fast and Screwless Bessey and Wolfcraft One-Hand Clamp to Workbench Clamp conversion — image 1
1 / 2

Fast and Screwless Bessey and Wolfcraft One-Hand Clamp to Workbench Clamp conversion

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fast Conversion of Bessey EZM or Wolfcraft PRO M One-Hand Clamp into a 20mm workbech clamp without any screws

Rating
5 / 5
Likes
24
Downloads
109
Makes
1
Views
831
Reviews
1

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

This is only the clamping part of my One-Hand Clamp Mod which allows the use of Bessey EZM and Wolfcraft Pro M directly on your perforated grid plate Workbench. This version works without an endstop and therefor doesn't need any Screws. As easy it is to install, it also can just slide of the rail… 

For best performance the Benchdog has to fit closely. Due to different accuracies/ tolerances of every printer and perforated grid plate i recomend you first print the "tolerance test". It is steped in 0.1 mm incremets from 19.7 to 20.2 mm diameter. 

In most cases 19.9 mm should be the right size.
Chose the lenght based on your workbenches thickness

It works with both Wolfcraft and Bessey size M

I also made a version with seperate Endstop here: https://www.printables.com/model/774798-bessey-wolfcraft-one-hand-clamp-to-20-mm-workbench

My original version can be found here: https://www.printables.com/model/773378-bessey-wolfcraft-one-hand-clamp-to-20-mm-workbench

Print settings:

8 Perimeters
50% Infill

Hardware:

no Hardware needed


Installation:

  1.  Remove fixed jaw
  2.  Push Benchdog with flange towards movable clamp jaw onto Rail 

Usage:

The Workpiece (pressure point) has to be placed as far as possible away form the clamps rail due to how this type of clamp works mechanically. If the workpiece (pressure point) is to close to the Rail the Benchdog will simply slide out. To improve clamping, tilt the Clamps Rail away from the workpiece while tightening.

Uninstallation:

  1. Pull Benchdog from Rail
  2. Reinstall original fixed jaw 

Notes:

If you dont mind the original jaws not fully closing you can “store” the benchdog on the Rail between them. 

Commercial Benchdogs have an undercut below the flange to sit flush against the table. This would reduce the strenght of a printed part and therefor was not included. However, if the holes of your perforated grid plate are chamfered or rounded this is no problem.

.step-files are provided in case you need a different diameter or want to adapt to other clamps. If you do feel free to add a remix.

 

Tags