1 / 3
Sun shades for the Hörmann EL101 barrier for garage door — image 1
1 / 3

Sun shades for the Hörmann EL101 barrier for garage door

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Quick and simple shades for the EL101 barrier to protect it from direct sunlight.

Rating
0 / 5
Likes
2
Downloads
32
Makes
0
Views
350
Reviews
0

Updated at source:

Model information

Category
Garage
License
Creative Commons — Attribution

One of the issues the Hörmann light barriers (EL101 at least, what I have) is that it is blind when illuminated by the sun resulting in inability to close the garage door in such situation. This applies to both the sender and the receiver. One has to shadow the sun for it to work again. Over the years I have improvised with various add-hoc materials but they eventually would fall out or look plain ugly.

So here are three variants of sun shades for this sensor I designed and experimented. All of them are made so that printing is easy, not requiring supports. You can print them from basically any material, they will usually last years, but if some breaks it is not critical and you can always print a new one. I printed mine in ABS mostly to test my all new enclosed Voron printer.

One of the designs uses the M5 bolt that attaches the barrier sensor to its base. You will however need a 5mm longer bolt. 

The other design slides from the top and is not held by any bolts etc. It should stay in place, but that might depend on the material you use to print it and your printer tolerances.  But if it flies away, just print a new one. 

Finally, a combo design that both slides from top and can be bolted. This one too, needs an 5mm longer M5 bolt.

Print all models laying on their back, without supports.

Print one for the sender and one for the receiver.

Tags