1 / 3
Simple Lattice iCE40-UP5K Case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A minimal, protective half-case for the Lattice iCE40-UK5K development boards, with heat set inserts and screws.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 98
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
A little case for the Lattice Semiconductor iCE40 UltraPlus Breakout Board. Check the list below for compatible boards.
The board should sit quite firmly in the case itself and is held down by additional screws.
Recommended Material & Print Settings
- Nearly every Material should work, Test prints were done in PLA.
- No supports needed.
- Two (or more) perimeters recommended for the screw pegs to be solid enough
Additional Hardware
- 4x M3x10 DIN 912 Cylinder Screws (between 8 and 10mm should be fine)
- 4x M3 Heat Set Inserts (CNC Kitchen ones tested, others may work as well)
Compatible Boards
- Lattice iCE40UK5K-B-EVN
- Possibly others?
Please consider liking the model and posting a Make :)