Polaroid 600 handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replacement handle for old Polaroid 600 round models
- Rating
- 4.5 / 5
- Likes
- 29
- Downloads
- 303
- Makes
- 4
- Views
- 1,379
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
“Design Work in progress; I havn't printed it, i designed it with a 3D scan i did with a scanner, it should work, BUT is not tested yet”
I'm in love with old Polaroid cameras, I have 2 of them, a Polaroid 600 rounds and a Polaroid 636. I never used the 600 round cause the handle was broken, and all same models on eBay were broken too cause of the old rubber, so I designed a 3D printable replacement made in TPU.
The idea is to make it a non permanent solution, not using glue, in case you find or make a better handle, be able to remove it without having to damage the camera.
In the visor section you should be able to bend the ring to insert the camera inside. On the opposite side it have 2 little screws to hold the piece in place from the cartridge compartment