Biqu B1 BLTouch mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The metal BLTouch mount included with the Biqu B1 was bent at an angle and couldn't easily be bent vertical, so I…
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 355
- Makes
- 0
- Views
- 1,890
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
The metal BLTouch mount included with the Biqu B1 was bent at an angle and couldn't easily be bent vertical, so I remixed this mount. It had too much adjustment for my needs, so I simplified the design which included by recesses to capture M3 nuts and an access hole for the adjustment screw.
Designed for and tested with a genuine BLTouch 3.1, so your mileage may vary if using a clone or a different version.
You will likely need to babystep your Z probe offset to suit your needs, but -1.5 is a good start.
Probe Offsets
Probe offsets are included in the filename, but they are also listed below:
#define NOZZLE_TO_PROBE_OFFSET { -1.5, -34, -1.5 }
BOM
- 1 x BLTouch 3.1
- 2 x M3 nyloc nuts
- 2 x M3 x 3mm or longer screws BLTouch Firmware
You can find a base Biqu B1 BLTouch firmware in the Marlin Configurations repo. Just adjust the probe offsets as mentioned above.