Biqu B1 BLTouch mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The metal BLTouch mount included with the Biqu B1 was bent at an angle and couldn't easily be bent vertical, so I…
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 355
- Wydruki
- 0
- Wyświetlenia
- 1890
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The metal BLTouch mount included with the Biqu B1 was bent at an angle and couldn't easily be bent vertical, so I remixed this mount. It had too much adjustment for my needs, so I simplified the design which included by recesses to capture M3 nuts and an access hole for the adjustment screw.
Designed for and tested with a genuine BLTouch 3.1, so your mileage may vary if using a clone or a different version.
You will likely need to babystep your Z probe offset to suit your needs, but -1.5 is a good start.
Probe Offsets
Probe offsets are included in the filename, but they are also listed below:
#define NOZZLE_TO_PROBE_OFFSET { -1.5, -34, -1.5 }
BOM
- 1 x BLTouch 3.1
- 2 x M3 nyloc nuts
- 2 x M3 x 3mm or longer screws BLTouch Firmware
You can find a base Biqu B1 BLTouch firmware in the Marlin Configurations repo. Just adjust the probe offsets as mentioned above.