Adaptable tray for telescope tripod (diameter 1.5 - 1.75 - 2 inch and 40mm)

Adaptable tray for  telescope, for 1.75 and 2 inch tripods, with different inclinations and optional holders for tablets.

(See also: https://www.printables.com/model/1040019-frame-for-models-of-telescope-trays )

After making several models adapted to the specific tripod of Skywhatcher mounts, I have made this design with the idea that it can be used for any tripod and can be reused from one equip to another.

The surface of the tray is 200 x 165mm.

The inclination of the tray is adjustable to leave it horizontal, according to the inclinations of the different tripods (Angle A: min 50°, max 68°) and is secured so that it does not move with a heavy load.

For the Suport and Brida pieces, there are two options that you should choose depending on the diameter of your tripod legs (1.75 or 2 inches).

To prevent rotation on the polished steel leg, I recommend the placement of an adhesive tape (painter's tape)

The design offers the possibility of tilting the tray to place a tablet in a more ergonomic position. Using the optional piece Forquilla_v2.stl, it inclines about 25°. Without a piece, it will lean until it rests on the leg of the mount, about 56°. These angles will vary slightly depending on the inclination of your tripod.

I have also added the optional Suport_tablet.stl pieces to hold the Tablet.

If your mount is the EQ5 or EQ6R pro, remember that you also have simpler, non-adjustable models to print:

https://www.printables.com/es/model/304688-new-tray-for-the-skywatcher-eq6-r-pro-mount

https://www.printables.com/es/model/636474-tripod-tray-for-eq5

Print material and settings

Prusament PETG is a good material for this model.

In the configuration files you will find the printing parameters that work and ensure a very strong device. All parts are printed without supports, except the tail of the forquilla.stl part

Note: Surely you will have to pass the drill through some hole so that the screws enter well. Do it carefully so as not to create gaps between the pieces.

Material addicional

     (x1)           Screw_M6x40_DIN933_ISO4017

     (x3)           Screw_M6x50_DIN931_ISO4014

     (x2)           Screw_M6x55_DIN931_ISO4014

     (x1)           Screw_M6x90_DIN931_ISO4014

     (x4)           Nut_M6_DIN934_ISO4034

     (x3)           Nut_M6_DIN985_ISO10511

     (x4)           Washer_M6_DIN125_ISO7089

Parts and Assembly

Finally, to transport the tray with your equipment, you can partially disassemble it and fold it as seen in the photo:

If you like it and print this model, I hope it will be very useful to you.

UPDATE I.

I have added the new parts:

Suport_1.50 and Brida_1.50 that are used to mount the tray on tripods with 1.5 inch diameter legs.

I have also included the suport_tablet_2 piece, identical to suport_tablet, but with a shorter length.

Likewise, I have included the suport_tablet.step file, so you can modify and adapt this piece to your convenience.

UPDATE II.

In this Update, I have added the new parts:

Suport_40mm.stl and Brida_40mm.stl, that are used to mount the tray on tripods with 40mm diameter legs. Valid for the new ZWO TC40 tripod.

To configure the printing parameters you can see the previous models. Thank you.