1 / 7
ST7796S TFT Display Enclosure
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The front and rear are held together with 10mm x 3mm round magnets. There are cutout slots on each corner to insert the magnets then back-fill with filament from a 3D pen or soldering iron.
The holes on the bottom of the case are for mounting/unmounting the display.
The detail isn't that great because I print with a .8 nozzle. For large items I prefer speed over aesthetics.
Print Times:
- Front stand: 8 hours
- Rear lid: 11 hours.
Cura Settings:
- Nozzle: .8
- Filament: Polymaker PolyLite White PLA
- Bed Temp: 78C
- Nozzle Temp: 220C
- Speed: 40mm/s
- Fan: 75%
- Tolerance: Middle