1 / 6
Resistors, diodes and similar through-hole components storage solution — image 1
1 / 6

Resistors, diodes and similar through-hole components storage solution

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Lightweight cards to efficiently store your through-hole ICs

Rating
5 / 5
Likes
42
Downloads
116
Makes
1
Views
1,050
Reviews
2

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution — Noncommercial

Since all of the storing solutions that I've found required too much filament for this simple task, I've decided to design my own.

One card can be printed with less than 7 grams of filament and can hold 3 “sheets” of resistors (3x20=60 resistors in one card). If your ICs are not attached to paper you can cut your own for your storing convenience.

Card size: 70x100x3.30mm

For reference I used PLA, 0.32 layer height and 0.6 nozzle.

Handy storage stand is included. It holds 12 cards, but you can make it bigger in slicer by cloning it over itself and moving it 10mm for each additional card you want to add.

Hot tips

Print with “normal” supports, with 0.25 top and bottom distance (also I used 4mm base pattern spacing, 1 top and 2 bottom interface layers). Position as shown below:

To remove supports in 30 seconds skip the flush cutters and use a sharp blade. Make 4 cuts on each side to disconnect the supports and simply take them out.

 

Buildplate positioning for the holder:

Tags