Resistors, diodes and similar through-hole components storage solution
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lightweight cards to efficiently store your through-hole ICs
- Ocena
- 5 / 5
- Polubienia
- 42
- Pobrania
- 116
- Wydruki
- 1
- Wyświetlenia
- 1050
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Since all of the storing solutions that I've found required too much filament for this simple task, I've decided to design my own.
One card can be printed with less than 7 grams of filament and can hold 3 “sheets” of resistors (3x20=60 resistors in one card). If your ICs are not attached to paper you can cut your own for your storing convenience.
Card size: 70x100x3.30mm
For reference I used PLA, 0.32 layer height and 0.6 nozzle.
Handy storage stand is included. It holds 12 cards, but you can make it bigger in slicer by cloning it over itself and moving it 10mm for each additional card you want to add.
Hot tips
Print with “normal” supports, with 0.25 top and bottom distance (also I used 4mm base pattern spacing, 1 top and 2 bottom interface layers). Position as shown below:
To remove supports in 30 seconds skip the flush cutters and use a sharp blade. Make 4 cuts on each side to disconnect the supports and simply take them out.
Buildplate positioning for the holder:
