Phone & Light Stand for Prusa Connect / PrusaLink

I wanted to combine a front facing light and a cellphone webcam into one unit for use with Prusa Connect. 

The Stand/Phone:

• The phone holder sits at a 10 degree angle. 
• The camera needs to sit about 30mm higher than the light to have a clear view.
• The stand can fit most phone sizes:
  • 130mm to whatever height
  • maximum width of 80mm
• The legs stick out in front of the light to counter balance the weight of the phone and provide a little more weight overall.
• Because the stand is on feet, you can run the cables out from any direction from underneath.

The Light/Screw:

• The included printable screw can hold a compatible light firmly in place. 
• You can purchase the light I have pictured from this Amazon link.
• The screw threading is compatible / comparable to any photography style female connector.

Supports:

• The STL I am providing is in one piece. I used Prusa Slicer to separate the feet from the body to reduce the quantity of supports overall. Of course you can print in one piece and use supports, it's up to you!
   
• Use the 3MF file to print the legs separate with connectors, if desired. Or create your own cuts using a slicer and the provided STL.

— if you are using the connector feet 3MF file, read below:

• The main body print will still require supports on build plate only. The support areas are the screw area and the phone holder hexagon backing.