Parkside Dual X20V batteries to Ferrex 40V Tool
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter to work on 40v Ferrex tool using 2 x20V Parkside batteries
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 114
- Makes
- 0
- Views
- 841
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Printed in 0.2mm in PETG
The assembly is pretty self explanatory and everything is held together with 8 screws.
The holes are threaded for M3 screws but fill free to use wood screws as well.
This requires 3mm screw with flat heads - you may have to sand the head a bit to make sure it fits in the holes (I didn't want to make the holes any bigger)
This fully inspired by https://www.printables.com/model/329125-parkside-dual-x20v-team-batteries-to-ferrex-40v-to
I have reused https://www.printables.com/model/329087-parkside-x20v-team-battery-in-ferrex-tool-battery- this design and adapted it
The positive and negative wires should be 16AWG. The fifth wire can be thinner as it serves to transmit the temperature sensor signal and does not need significant current.
The part labeled B1 should have 3 wires, one positive and one negative and one which is the temperature sensor.
Positive is marked with +, negative with - and sensor with T.
The part labeled B2 should only have positive (+) and negative (-) wires.
The three wires from the B1 part must connect to the Ferrex part in the slots marked B1-, T and B1+.
The two wires from the B2 part must connect to the Ferrex part in the slots marked B2- and B2+.
The slots for inserting the terminals are very tight so they can stay in place until you apply the glue, so it takes a little effort and patience to insert the terminals.
I recommend hot glue to secure the terminals in place.
Do not use the Ferrex charger to charge the Parkside battery.
