Keystone Jack Punchdown Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted a better way to punch down keystone jacks rather than holding them in my hand.
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 147
- Makes
- 1
- Views
- 756
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a better way to punch down keystone jacks rather than holding them in my hand (which quickly gets tiresome) or using a scrap of wood etc., so I created this holder. I rounded the corners to add comfort and reduce fatigue. It works equally well on a hard surface or in the hand, and really comes in handy when working on a ladder or in awkward situations. Takes up very little room in your toolkit and you can carry it in your pocket comfortably all day.
The original version (v.02) works with Leviton keystones. I added a newer version (v.03-cm) which works with Cable Matters keystones as well as Leviton keystones. Version 03 was done completely in OpenSCAD using minkowski to round the corners.
Running ethernet cables? Check out my Easy Cable Management Clips.
Print Settings
Rafts:
No
Supports:
No
Resolution:
low/3mm layers
Infill:
15% wide honeycomb
How I Designed This
Basic design in OpenSCAD, saved as .stl, imported .stl into 123D, converted to a solid, then used the fillet tool to round the edges. Doing it all in OpenSCAD with minkowski would have taken more time.
Category: Electronics