Flexi Raptor
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.81 – €2.21 net (excluding VAT)
For file: Sir Flexi Raptor Prusa Mini / sir_flexi_raptor_02mm_pla_mini_2h24m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.01 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 2.4 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A flexible velociraptor! How cool! This is a very flexible (with 19 joints!
- Rating
- 4.897 / 5
- Likes
- 2,320
- Downloads
- 13,187
- Makes
- 288
- Views
- 32,038
- Reviews
- 223
Updated at source:
Model information
- Source
- Printables
- Category
- Animals
- License
- Creative Commons — Attribution — Noncommercial
A flexible velociraptor! How cool! This is a very flexible (with 19 joints!), print-in-place model I spent a long time designing. A lot of attention to detail is in this model, and a few of the smaller tail links are weak due to their size so be careful! He can stand on his own or hang from something; he can even bite his own tail! He should print and pop off the board in a completely flexible state. He seems happiest when hanging from a computer monitor. Have fun!
Not suitable for small children, the tail end pieces may be fragile and could break off and be swallowed.
Check me out on Thingiverse: https://www.thingiverse.com/Cavedog/about
Check me out on MyMiniFactory: https://www.myminifactory.com/users/Cavedog
Print instructions
Make sure you print him on his RIGHT SIDE. His tail is tapered and I designed him so that his tail sits flat with the right side of his body for printability. No supports or rafts are needed. I used 210° first layer temp, 205° printing temp, 60° bed temp for best results. My printer is dialed in well; if you experience issues I suggest printing at least 125% scale, slow down a little and try slightly higher or lower temperatures.