1 / 4
Converting an In-line extractor into an air filtration unit — image 1
1 / 4

Converting an In-line extractor into an air filtration unit

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Convert a standard inline extractor into an air filtration with these parts and hepa filters

Rating
0 / 5
Likes
4
Downloads
11
Makes
0
Views
109
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

Here is a set of models that can be connected to a 100mm inline extractor and convert it into an air filtration unit - i use it in my woodwork shop.

It requires:

  • 1x 800mm m6 threaded rod1x m6 nylon lock nut
  • 1x m6 penny washer
  • 1x m6 wingnut
  • 1 or 2x hepa filters

 

If you are printing the single filter variety as i have in my pictures, you can skip on the two joining ring parts and the 2nd filter.

As per the pictures i found a single filter to be light enough that it stays in place without using the mounts (i've included them just in case you need to print them).

The nylon nut goes in the extractor end, the penny washer and wingnut would apply pressure from the filter end (not seen in my photos as i didnt need them).

Big printed parts should have a brim and supports, the smaller parts do not need the brim.

Tags