SKADIS BERNINA bobbin and thread spool holder - Faden und Näh-Spule
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.22 – €0.27 net (excluding VAT)
For file: skadis_SPOOL_top_normal_0.4n_0.2mm_PETG_MK4IS_18m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.24 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 18 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Thread Spool holder for SKADIS, for different sizes with bobbin
- Rating
- 0 / 5
- Likes
- 56
- Downloads
- 166
- Makes
- 0
- Views
- 1,219
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Zweiteiliger Druck!
Gemacht für verschiedene Fadenspulen Grössen und speziell für BERNINA Nähmaschinenspulen.
Die zwei Teile können einfach mit z. B. Sekundenkleber zusammen geklebt werden.
Die beiden oberen Teile sind unterschiedlich gross, einer ist für ganz grosse Spulen (z. B. Gütermann 800m) und der andere ist für alle „normalen“ und kleinere Spulen.
Beide oberen Teile passen auf den unteren Teil.
D.h. es muss immer je ein oberes und unteres ausgedruckt werden. →Siehe Bilder.
***
Two-part print!
Made for different thread spool sizes and specifically for BERNINA bobbin.
The two parts can be easily combined with e.g. B. superglue can be glued together.
The two upper parts are different sizes, one is for very large spools (e.g. Gütermann 800m) and the other is for all “normal” and smaller spools.
Both upper parts fit on the lower part.
This means that an upper and lower one must always be printed out. →See pictures.
***
Einstellungen/ Settings:
Made with PETG, Print-in-Place, Support as you like, I printed without supports.
0.20 mm Layer, Structural