1 / 6
Remix phone holder fiat panda
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of phone holder to have a ball joint and replace the angle part of the dashboard
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 156
- Makes
- 2
- Views
- 1,476
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Share Alike
phone support adapter for fiat panda older model where there is a corner of the dashboard covered with just a piece of plastic. I basically designed it to print and adapt to the ball joint and phone holder so the original piece is intact.
-M5 bolt or rod is needed to give strength to the ball joint
-may require some sanding to adapt the pieces and super glue for the base
-4 M3 short screws or small seft tapping screws are needed for the phone holder
Refer to the original model for instructions.