TRS jack 90º angled Sleeve
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.14 – €0.17 net (excluding VAT)
For file: Locking ring.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.15 excluding VAT (range midpoint).
- Weight reported by the author
- 2 g
- Print time reported by the author
- 9 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Conversion of TRS straight jacks that protrude too much for the required application. From a size of 50mm to 20mm.
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 100
- Makes
- 0
- Views
- 431
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
1.Necessity.
Incompatibility due to size of TRS straight jacks that protrude too much for the required application.
From a size of 50mm to 20mm.
2. Solution.
Manufacture with MDF printer (Fused Deposition Modeling) an angled housing where the standard commercial TRS ¼" connector can be adapted.
3. Manufacturing steps.
3.1. Connector measurements.
We start from a standard TRS connector of ¼", 6.3 mm Ø.
Wide part where thread 10.9 mm Ø
3.2. Design and printing of parts
A set of 3 parts is designed to facilitate the assembly and sealing of the connector after soldering the wires.
3.2.1. Part 1 JACK
Piece with measures that allow to house the connector and bend the pin to hold the cable and solder the ground.
Printed pin in PLA 0.15 layer height with supports.
3.2.2. Part 2 JACK TOP
Lid to cover and fit with the bottom piece.
The protrusion on the circular part pushes the JAKC to stay in position and fit.
The other protrusions to fit the JAKC without any possibility of displacement.
3.2.3. Piece 3 Open clamping ring
The ring allows the two parts to be joined together.
The cut in the piece allows, given the elasticity of the material, the opening for the passage of the cable and its placement.
3.3. Finished product.