1 / 3
Ender 3 Max Neo Fan Shroud for Spark Hot end — image 1
1 / 3

Ender 3 Max Neo Fan Shroud for Spark Hot end

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fan Shroud for ender 3 Max Neo With a spark hot end or other smaller hotends.

Rating
0 / 5
Likes
7
Downloads
33
Makes
0
Views
691
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

I was having issues with heat creep on the factory hot end so I upgraded to the spark hot end I wanted to change to a larger cooling fan and no fan mounts for this hot end exist so Here is my take on a hot end fan for the creality ender3 max neo with a spark hot end and upgraded 4020 fan.    This may work on other smaller hotends possibly on the factory hot end my factory hot end is trashed so I have no way to test it.

I Printed using creality hyper pla and so far its been holding up pretty well even with high temp PETG prints.   I printed face down supports on bed at .2 layer height.  There are 3 different fan cover options.

Parts needed to complete 

1- 4020 axial fan.  I used a ball bearing fan but any 4020 fan will do. You could also use the factory 4010 if you wanted.

 

Install is pretty straightforward but here is  the rundown.

  1.  Slide fan into the housing with the correct fan orientation route your wire up to the hot end fan in your loom.

3. Cut and solder the new cooling fan to the power for the hot end in the main harness.  Make sure an use heat shrink on the solder joints to keep them from shorting out.  Slide your cover on.   The shroud mounts by sliding onto the CR Touch probe mount.   

Tags