Angle/Sin Vice Jaw for Machinist 6" Vices.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Vice Jaw that uses pins and any flat reference bar to set the angle for the part. STEP file included.
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 149
- Makes
- 0
- Views
- 838
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
Fits standard 6" (Kurt) machinist vices where bolt holes are 3.875" from center of each other.
Use two pins that correspond to the angle you want (ex. for 0, 1, 2, 3, etc. degrees need to have a pin on in one of the A's on the left side and a pin in the A bore on the bottom right. Same rule applies to the B's.)
The bores require a 1/8 (.125") pin and any flat reference surface to lay on top of the two pins. (A ruler, or straight edge).
You can 3d print for a vice if you're only putting light pressure, otherwise this should be machined for longevity. STL and STEP file included.