Mini Wire Clamp / Wire holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mini clamp for holding together two wires when you don't want to solder them or want quick interchangeability.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 57
- Makes
- 0
- Views
- 370
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This is a mini clamp for holding together two wires when you don't want to solder them or want quick interchangeability.
It is a tight fit at first, but it loosens up after a couple of uses. Try using pliers to rotate the screw the first time if it's not going in easily.
You can try scaling up the holder part if it doesn't fit, or is too tight.
Print settings
Print orientation: print as in .3mf file.
Print in PLA
0.08mm layer height ( or whatever smallest layer height you can do)
100% infill
print order: infill → inner → outer
no supports needed