1 / 5
Light guide for the Neo Pixel LED of the OpenMower Mainboard — image 1
1 / 5

Light guide for the Neo Pixel LED of the OpenMower Mainboard

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Light guide to display the neo pixel outside the housing.

Rating
0 / 5
Likes
2
Downloads
19
Makes
0
Views
196
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The OpenMower mainboard (mine is v0.11.x from the Gadgets By Vermut kit) has a neo pixel LED to show the various states. However, when the housing is closed, you cannot see it from the outside.
I had transparent polycarbonate 3d printer filament at home and tried to use it as a light guide to make the display visible from the outside. It works surprisingly well.

The system consists of the following simple components:

  • the clip that encloses the LED and fixes the light guide over it (print it in the same orientation as shown on the picture, carefuly slide it over the led)
  • Light guide feed-through through the housing (drill a 4mm hole, press it in from the outside, it fits quite tight, fix and seal it with super glue to the housing from the inside)
  • a corner piece for better guidance of the filament (I used a second print of the clip, cut off the base and pushed it over the filament)
  • the light guide itself (about 15cm 1,75mm filament, push it completely into the clip an into the feed-through, fix and seal it with super glue)

I used very little glue to prevent the filament from becoming opaque. I'm not afraid of the housing leaking and I think the glue will hold tight - but time will show ;)

Related links:

Tags