1 / 5
Light guide for the Neo Pixel LED of the OpenMower Mainboard — zdjęcie 1
1 / 5

Light guide for the Neo Pixel LED of the OpenMower Mainboard

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Light guide to display the neo pixel outside the housing.

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
196
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The OpenMower mainboard (mine is v0.11.x from the Gadgets By Vermut kit) has a neo pixel LED to show the various states. However, when the housing is closed, you cannot see it from the outside.
I had transparent polycarbonate 3d printer filament at home and tried to use it as a light guide to make the display visible from the outside. It works surprisingly well.

The system consists of the following simple components:

  • the clip that encloses the LED and fixes the light guide over it (print it in the same orientation as shown on the picture, carefuly slide it over the led)
  • Light guide feed-through through the housing (drill a 4mm hole, press it in from the outside, it fits quite tight, fix and seal it with super glue to the housing from the inside)
  • a corner piece for better guidance of the filament (I used a second print of the clip, cut off the base and pushed it over the filament)
  • the light guide itself (about 15cm 1,75mm filament, push it completely into the clip an into the feed-through, fix and seal it with super glue)

I used very little glue to prevent the filament from becoming opaque. I'm not afraid of the housing leaking and I think the glue will hold tight - but time will show ;)

Related links:

Tagi