JK Wrangler Dash Cubby 2 Switch Bezel (for e-locker switches)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Created a factory looking switch panel for 2 e-locker switches located in dash cubby (manual window models only)
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 84
- Makes
- 0
- Views
- 782
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Created a factory looking switch panel for front and rear e-locker switches that requires no visible holes to be drilled and can be reverted back to stock if needed.
I put a wire connector plug at the back of the cubby for ease of installation & future removal (getting into dash).
Switches used: https://www.amazon.com/stores/StarkIndustries/page/331A87BC-FBDA-4FAF-AA95-CC2FAC844CB8?ref_=ast_bln
Print in PETG for temperature resistance.
There are screw holes that align with existing holes in bottom of cubby. Use 3mm machine screws.
The top is held by drilling a small hole in the top of the cubby, smaller hole in bezel plate and use a 3mm screw.
