JK Wrangler Dash Cubby 2 Switch Bezel (for e-locker switches)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Created a factory looking switch panel for 2 e-locker switches located in dash cubby (manual window models only)
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 782
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Created a factory looking switch panel for front and rear e-locker switches that requires no visible holes to be drilled and can be reverted back to stock if needed.
I put a wire connector plug at the back of the cubby for ease of installation & future removal (getting into dash).
Switches used: https://www.amazon.com/stores/StarkIndustries/page/331A87BC-FBDA-4FAF-AA95-CC2FAC844CB8?ref_=ast_bln
Print in PETG for temperature resistance.
There are screw holes that align with existing holes in bottom of cubby. Use 3mm machine screws.
The top is held by drilling a small hole in the top of the cubby, smaller hole in bezel plate and use a 3mm screw.
