The 100 Modular CPAP Toolhead
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A modular CPAP toolhead for The 100 printer.
- Rating
- 4 / 5
- Likes
- 27
- Downloads
- 171
- Makes
- 1
- Views
- 1,574
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The design is intended to have easily swap-able cooling ducts so better duct designs can be installed in the future.
The design is for the CHC Pro hotend.
Recommend using a WS7040 fan with this enclosure: https://www.printables.com/model/751151-ws7040-cpap-fan-enclosure
toolhead_gates.stl has belt spacing for use with the Gates version of https://www.printables.com/model/781510-the-100-rigid-gantry. If using the non-Gates version of the rigid gantry or the The 100 v1.1 gantry use toolhead.stl instead.
Requires m3 heat inserts for the hotend clamp, a 4010 cooling fan, screws to screw the clamp to the toolhead, and screws to screw the fan into the plastic frame.
Print Settings
- Toolhead and Fan Mount
- 0.2mm layer height
- 0.5mm line width
- 3 walls
- 25% cubic infill
- Duct
- 0.12mm layer height
- 0.5mm line width
- 3 walls
- 25% cubic infill
Changelog
- v1.1
- Added versions for bambu hotends, also including bltouch mounts. Note that hotend fan must always be hooked up or there is a risk of melting the mount. Also it is best to install the hotend with filament threaded partway through before tightening the mount screws to make sure everything is aligned. Also note that the hotend mount screws should have threadlocker as they are prone to loosening.
- Improved airduct flow.