1 / 4
Thermalright AXP-100 Full Copper 120mm fan mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
120mm fan mount for AXP-100 Full Copper which replaces original 92mm bracket
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 46
- Makes
- 0
- Views
- 960
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Public Domain
120mm fan mount for AXP-100 Full Copper which replaces original 92mm mount and increases effective surface area(due to removed obstruction of original mount+adapter) without increasing overall cooler heigh.
BOM:
- 4xM3xD5xL4 threated heat inserts
- 4xM3x20 screws (for 15mm thick fan),
You can use M3 screws from cooler package but shorter ones won't reach thread, while longer one will protrude by ~5mm and you have to be careful to not screw them into your RAM or whatever else is happened to be under screw hole
Printing recommendations:
- AXP-100 is a SFF cooler and it will never be cold enough for low temp plastics, i recommend to use filament which heat deflection is higher than yours throttle temperature, i use ABS-CF15 for this task with CPU limited by 85C
- Part is oriented for printing, no supports required
- 4 perimeters and 30% infill with .4 nozzle, 4 top 4 bottom solid layers should be more than enough for this part to be strong if printed with ABS-CF
Assembly:
- Remove original 92mm mount(original screws are going to be used to screw mount so don't put them far away)
- Put heat inserts into outer holes from the top side(print orientation)
- Screw mount to the fan(it is essential step to have perfectly flush mounting which won't destroy cooler mount lugs after cooler installation on the motherboard)
- Place cooler on top of mount+fan and screw it with original screws
- Unscrew fan for easier motherboard mounting process
