1 / 2
Saw Guide Collar for cutting 1" , 1-1/8" , & 1-1/4" Bike Steerer Tubes — image 1
1 / 2

Saw Guide Collar for cutting 1" , 1-1/8" , & 1-1/4" Bike Steerer Tubes

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Use alone or as a pair to guide hacksaw blade while cutting a bike steerer tube to size.

Rating
5 / 5
Likes
19
Downloads
204
Makes
5
Views
1,425
Reviews
4

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

Saw Guide or Cut Guide collars for cutting bike steerer tubes down to size. Designed for Metal Steerer Tubes. Slightly undersized to ensure a tight fit on the steerer. 

Carbon Steerer Warning:

Clamping anything on a carbon steerer tube without internal support can result in invisible delamination damage and steerer tube failure. These clamps are not designed for carbon steerer tubes and should be used at your own risk. If you decide to use these on a carbon steerer tube, minimal clamping force is recommended and they should probably be slightly scaled up to be a slip fit on the steerer. 

Print specs:

Works well printed in PLA @ 65% infill @.3mm layer height

Collars are 17mm tall. Reduce as needed before printing.

Tinkercad file: https://www.tinkercad.com/embed/2PW2VmnAyaU

Intended hardware:

1x 3/16" (4.7mm) diameter bolt approximately 1"(25.4mm) long  with bolt head no wider than 3/8"(9.5mm)

1x nut measuring ~3/8" flat to flat (9.5mm)

Bolt hole is slighty undersized. Can be drilled out for a larger bolt. 3/16th bolt will cut threads in plastic which may be sufficient without a nut. (heat your bolt and nut in boiling water before install to get a “heat set” fit)

Use:

Measure twice, cut once! You can't undo a steerer cut and you can always use spacers to account for a steerer slightly too long. Having to cut a second time is always better than cutting too short the first time. Cut slowly and use light pressure for best results. Let the saw do the work.

For threaded steerers, thread the top adjustable race onto the steer then attach your collars. This will allow you to clean up the threads by unscrewing it after cutting.

Collars are slightly undersized to ensure a tight fit on the steerer. spread the collar to slide it on the steerer. 

Use the saw blade to set the gap between collars. The saw will widen the gap as you cut by removing collar material. 

If there is too much friction, increase the gap slightly. On threaded steerers, the top collar can be “unthreaded” to micro adjust the gap.

Will work at least twice by flipping the collars around for the second cut. will work multiple times if the surfaces touching the saw blade sides are still flat.

Once the blade is ¼ of the way through the steerer, the top collar can be backed off or possibly even removed to reduce friction on the blade.

Finish the cut with a file or rasp to remove and burrs and bevel the top edge to roughly 45 degrees. This allows for easier threading of the headset cups.

Tags