Voron V0.2 LDO Kit Reference Plate Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder for the LDO kit reference metal plate that comes with V0.2 LDO kit.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 66
- Makes
- 1
- Views
- 395
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution
The LDO metal plate (20x50x0.9 mm) should fit well in its slot if your printer is dimensionally accurate. Play with the "X-Y hole compensation" setting if it's too wide / thin (be careful to keep the 3mm screw hole diameter correct as well).
You only need 2 x M3x8 mm or M3x10 mm screws to attach the holder to the 1515 extrusions of the V0.
If the bridge under the metal plate falls down a little bit (see photo), you can just push a little bit with the metal place to reform it.
Stick the plate with a drop of glue once it is mounted on the printer.
Recommended printing parameters :
- Use ABS or ASA, PLA works as well since it's not exposed to heat as much.
- 25% infill
- 3 perimeters
- At least 3 top and bottom layers.