Voron V0.2 LDO Kit Reference Plate Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the LDO kit reference metal plate that comes with V0.2 LDO kit.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 395
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The LDO metal plate (20x50x0.9 mm) should fit well in its slot if your printer is dimensionally accurate. Play with the "X-Y hole compensation" setting if it's too wide / thin (be careful to keep the 3mm screw hole diameter correct as well).
You only need 2 x M3x8 mm or M3x10 mm screws to attach the holder to the 1515 extrusions of the V0.
If the bridge under the metal plate falls down a little bit (see photo), you can just push a little bit with the metal place to reform it.
Stick the plate with a drop of glue once it is mounted on the printer.
Recommended printing parameters :
- Use ABS or ASA, PLA works as well since it's not exposed to heat as much.
- 25% infill
- 3 perimeters
- At least 3 top and bottom layers.