Soapdish mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mod for my soapdish that wasn't draining enough water.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 16
- Makes
- 0
- Views
- 80
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Public Domain
To avoid the soap to sog on the dish I designed a grid to create separation between soap and base.
Given the difficulties to measure the soap dish accurately and the low amount of filament I had left, I also designed a separation ring. This was needed to perfect the fit since the grid would wiggle in the soapdish and wasn't high enough to drain the water properly.
I printed them in two different prints and with lower layer quality for the ring since it's not visible when “assembled”. But this is not critical for production.
Material:
I used PLA for the first proptotipe because of availability. No doubt that, ABS would be a better material for something that is always in conctact with water.
I also used concentric lines pattern for the bottom and top layers as the provide the best watertightness.