Oculus/Meta Quest 2 3D Scan/Model

The original 3D Model by stevesch over on Thingiverse (Here is the link: https://www.thingiverse.com/thing:4683038 ) was very good but there were some artifacts from the 3D scanning process under the joysticks, in the mounting holes for the facial interface and the lenses that I cleaned up. (there are also artifacts in-between the mounts for the head strap and the main body of the quest, and another spot around the lenses but I could not figure out a good way to get rid of those) It's not perfect, but it's pretty good.

You can use these 3D models to create accessories for the Oculus/Meta Quest 2, print them, or do whatever you want with them.

If you have an Oculus/Meta Quest 2 and the Oculus/Meta Quest 2 Elite Strap With Battery Pack and would like a charging dock accessory for it I have one available at the following link: https://www.thingiverse.com/thing:6003411

If you would like 3D models to use to make accessories for the Oculus/Meta Quest 3 headset I have 3D models of the Oculus/Meta Quest 3 headset and the Oculus/Meta Quest Touch Plus Controllers available at the following link: https://www.thingiverse.com/thing:6419366

If you like this 3D model please consider leaving a like. I hope you find this 3D model helpful and feel free to leave a comment if you have any questions or comments. If you do end up printing this 3D model please remember to come back to post a make! Happy Printing and Enjoy Everyone!!!

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 v2

Rafts:

No

Supports: 

Yes

Resolution:

0.2 mm

Infill: 

20%

Filament: JAYO PLA White

Category: Video Games