Microscope RMS DIN dust caps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Here the dust caps for microscope objective and nosepiece. They have RMS /DIN thread, 0,800 Inch 36 tpi. The fit is…
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 96
- Makes
- 2
- Views
- 368
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Here the dust caps for microscope objective and nosepiece.
They have RMS /DIN thread, 0,800 Inch 36 tpi.
The fit is very loose, to allow low-quality prints to work.
Yes yes I'm studying OpenSCAD... but for now, .stl only
Print Settings
Rafts:
No
Supports:
No
0,1-0,2
Filament: Ultimaker Whatever Burgundy
Notes:
If positioned with the flat face down, they will not need rafts or supports.
Use high resolution to get a decent thread. They should work with any plastics, I used PLA.
If they come out too loose or too tight, you may scale the whole solid by plus or minus 0,5%
Category: Parts