1 / 2
Extremely inexpensive stringing test
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extremely inexpensive and fast to print stringing test!
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 77
- Makes
- 4
- Views
- 259
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution
This is a very simple, inexpensive, and fast-to-print stringing test.
It takes 3-4 minutes to print with a printing speed of 70 mm/s and a travel speed of 175 mm/s.
The gab is about 3 cm wide.
As a bonus, here are my retraction settings in PrusaSlicer for my Anycubic Kobra 2 with ESUN PLA+:
| Printing temperature | 207 C° |
| -- | -- |
| Use ramping lift | yes |
| Maximum ramping lift | 0.9 mm |
| Ramping slope angle | 1° |
| -- | -- |
| Retraction length | 2.5 mm |
| Retraction Speed | 65 mm/s |
| Retract on layer change | yes |
| Wipe while retracting | yes |
| Retract amount before wipe | 70% |
I found out that at the end the "Ramping slope angle" helped with stringing the most (try to keep it low), besides the nozzle temperature of course.