1 / 3
Unifi US-XG-6POE Switch mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needed to Mount a US-XG-6POE under a desk.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 62
- Makes
- 1
- Views
- 346
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed to Mount a US-XG-6POE under a desk. Drafted this up and very happy with it!
No supports needed. If printed in a high-temp PETG or ASA you can likely get away with just the front mount. However, adding the rear wouldn't be bad insurance.
The Switch can get warm enough that PLA may not be a good long-term solution with its lower glass transition temp.
Notes:
High-temp filament is best (PETG, ASA, Etc...). The Switch can get warm enough that PLA may not be a good long-term solution with its lower glass transition temp.