DIY CNC Scratcher for pictures, writing, logos, etc on Granite, Glass, Wood, Marble
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Makes very nice pictures on any hard surface, uses cheap Diamond tips for Dental use that cost 1-2$ for 3 to 5 pictures
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 55
- Makes
- 0
- Views
- 383
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
17.05.2024 : Added the FreeCAD file although new versions of FreeCAD make a mess out of the assembly, no idea why it worked fine on last years versions of FreeCAD.
I am calling this "scratcher" from now on, all it does is scratch the surface of granite or stone or glass or wood or... any hard surface.
So, i thought it would be nice to do a new design for these machines i keep making from time to time and since i had to learn FreeCAD again, i gave it a go, so here are the results of the Version 2
Attached are all stl files and a zip with configuration for running the machine with LinuxCNC (see www.linuxcnc.org free, open source machine controller) .
Uses a metal frame, round linear rods/rails, 3 of Nema17 stepper motors, 1 DC motor, and a 3 phase servo motor from old photocopiers as pressure motor.
much more info on
https://forum.linuxcnc.org/show-your-stuff/46752-new-design-for-a-cnc-engraver-etcher-scratcher
Edit:
Pressure motor info:
The "pressure" motor is :
-a 3 phase BLDC motors with it's own electronic controller taken out of the old photocopiers,
-there are many versions and sizes of them,
-form 5 to 10 pins,
-all signaling is sinking type or "active low", meaning connect to ground to activate
-all have the pinout printed on the board,
-older ones are pure PWM while new ones require also a clock signal,
-some are single direction while some are bidirectional,
-and most of them can be easily used for this purpose/machine,
--The PWM ones require 5V, 12-24V and an inverted PWM signal
--The ones requiring clock signal have a self check feature, so mostly work with only 12-24V supply and one of the pins tied to ground, this pin will spin the motor for about 2 second and stop, and has to be disconnected and reconnected to spin again. This pin is used as inverted PWM but scaling must be set to about max 85-95% PWM to keep the controller from tripping and stopping the motor after 2 seconds.
--for inverting the PWM pin i use a single 220 OHm resistor and a single transistor, any NPN transistor works, resistor connected between base of transistor and PWM output from PC or Mesa board.
Videos of them in use: