DIY CNC Scratcher for pictures, writing, logos, etc on Granite, Glass, Wood, Marble
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Makes very nice pictures on any hard surface, uses cheap Diamond tips for Dental use that cost 1-2$ for 3 to 5 pictures
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 385
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
17.05.2024 : Added the FreeCAD file although new versions of FreeCAD make a mess out of the assembly, no idea why it worked fine on last years versions of FreeCAD.
I am calling this "scratcher" from now on, all it does is scratch the surface of granite or stone or glass or wood or... any hard surface.
So, i thought it would be nice to do a new design for these machines i keep making from time to time and since i had to learn FreeCAD again, i gave it a go, so here are the results of the Version 2
Attached are all stl files and a zip with configuration for running the machine with LinuxCNC (see www.linuxcnc.org free, open source machine controller) .
Uses a metal frame, round linear rods/rails, 3 of Nema17 stepper motors, 1 DC motor, and a 3 phase servo motor from old photocopiers as pressure motor.
much more info on
https://forum.linuxcnc.org/show-your-stuff/46752-new-design-for-a-cnc-engraver-etcher-scratcher
Edit:
Pressure motor info:
The "pressure" motor is :
-a 3 phase BLDC motors with it's own electronic controller taken out of the old photocopiers,
-there are many versions and sizes of them,
-form 5 to 10 pins,
-all signaling is sinking type or "active low", meaning connect to ground to activate
-all have the pinout printed on the board,
-older ones are pure PWM while new ones require also a clock signal,
-some are single direction while some are bidirectional,
-and most of them can be easily used for this purpose/machine,
--The PWM ones require 5V, 12-24V and an inverted PWM signal
--The ones requiring clock signal have a self check feature, so mostly work with only 12-24V supply and one of the pins tied to ground, this pin will spin the motor for about 2 second and stop, and has to be disconnected and reconnected to spin again. This pin is used as inverted PWM but scaling must be set to about max 85-95% PWM to keep the controller from tripping and stopping the motor after 2 seconds.
--for inverting the PWM pin i use a single 220 OHm resistor and a single transistor, any NPN transistor works, resistor connected between base of transistor and PWM output from PC or Mesa board.
Videos of them in use: