E-Flite Habu SS 70mm nose
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A lightweight nose for the Habu Jet
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 54
- Makes
- 0
- Views
- 343
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
My original nose is a bit squished and was heavy anyway. This one is significantly lighter because the wall is just .4mm thick, can be slightly dented to the side, but also goes straight back to its original state.
PLA is supposed to soften in the sun, but it has worked well for me so far. But PETG is certainly better in the long run.
Extrusionsfactor 1.17
This lace is printed in !vase mode! 0.3mm layer worked well for me and after 15min. the tip is ready and can be glued on with UHU Por. If you're not that precise when landing, you might just print a small supply and stack them...