E-Flite Habu SS 70mm nose
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A lightweight nose for the Habu Jet
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 343
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
My original nose is a bit squished and was heavy anyway. This one is significantly lighter because the wall is just .4mm thick, can be slightly dented to the side, but also goes straight back to its original state.
PLA is supposed to soften in the sun, but it has worked well for me so far. But PETG is certainly better in the long run.
Extrusionsfactor 1.17
This lace is printed in !vase mode! 0.3mm layer worked well for me and after 15min. the tip is ready and can be glued on with UHU Por. If you're not that precise when landing, you might just print a small supply and stack them...