Door vent v2 100x300mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Updated version of my door vent. Dimensions are more like commercial version. Can be printed in two parts (Ender 3).
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 52
- Makes
- 0
- Views
- 298
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
Updated version of my door vent. You can put it on doors, printer enclosures, dehydrators, pretty much anywhere where you need airflow.
Face is 1.5mm in height and 10mm offset, rear side is 15mm. Doors should be at least 30mm thick. Dimensions are 120x320mm, cutout should be 100x300mm. Can be printed in one piece or two pieces and then glued together. I have Ender 3 so i made a bit smaller version which can be printed side by side at one time if you don't use brim or raft (95x300). I printed it without raft/brim and it ended up fine, I've printed 4 of them (2 pairs) so far and didn't have any issues. v2 is a bit thicker and without support in the middle, but it has same dimensions. It can only be printed on bigger printers.