Magnetic Nerdland (or other) Calendar Mount

This 3D-print can hold a Nerdland (or similar) calendar on a magnetic board.

The model consists of five parts:

• 1 mounting plate with insets/holes for magnets
• 2 pins with threads on both ends
• 2 bolts

Important! The print and mounting instructions:

• Start print
• Pause the print right before the last layer (can be set in Prusa Slicer)
• Insert the magnets in the holes/insets (magnets to use: neodymium 6 x 2 mm. for example: https://www.bol.com/be/nl/p/ronde-platte-neodymium-magneetjes-100-stuks-6-x-2-mm-zeer-sterk-neodymium-magneet-koelkast-whiteboard/9200000113335759/?s2a=
  (See photo for clarification)
• Finish the print
• Screw the two pins on the mounting plate
• Insert the calendar in the pins en secure with the two bolts
• Enjoy your calendar!

Tips!

• Use small layer height (0.15 for example). Because this way the magnets ars closer to the board and the calendar mount will ‘sticks’ better.
• If it's not ‘sticky’ enough you can roughen the bottom with some sandpaper.