Zeepro Bushing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The Zim Zeepro is a fun little printer, but the designers took a few shortcuts that can be annoying.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 22
- Makes
- 0
- Views
- 235
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
The Zim Zeepro is a fun little printer, but the designers took a few shortcuts that can be annoying. One of those shortcuts is not doing a better job of securing the 6 mm shafts that the carriage rides on. Over time, they can push themselves through the support blocks and jam the mechanism. (I didn't take the mechanism apart, but I think they are just held in by prayers and good wishes.)
I printed a couple of bushings for each shaft, held together by M2x8 screws and nuts (although in my particular print, the holes threaded to the screws just fine and I didn't need the nuts at all).
Just install 1 bushing at each end of each rod to prevent it from sliding and you're good to go.