Zeepro Bushing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Zim Zeepro is a fun little printer, but the designers took a few shortcuts that can be annoying.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 235
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The Zim Zeepro is a fun little printer, but the designers took a few shortcuts that can be annoying. One of those shortcuts is not doing a better job of securing the 6 mm shafts that the carriage rides on. Over time, they can push themselves through the support blocks and jam the mechanism. (I didn't take the mechanism apart, but I think they are just held in by prayers and good wishes.)
I printed a couple of bushings for each shaft, held together by M2x8 screws and nuts (although in my particular print, the holes threaded to the screws just fine and I didn't need the nuts at all).
Just install 1 bushing at each end of each rod to prevent it from sliding and you're good to go.